Turbosmart BLOW OFF & BYPASS VALVE KITS - Dual Port for: Manuel d'utilisateur télécharger pdf (Page 3)

IMPORTANT NOTES ON SETTING THE SPRING TENSION

- Adjustment to the BOV is made by rotating the cap. To increase spring tension rotate in the direction of hard, marked on the top of

the cap

- Rotate the cap in the direction of soft to decrease the spring tension – CAUTION

Do not rotate the cap beyond the red indicator

groove

- With the engine at idle the exhaust ports should be closed off by the piston – the piston should be hard against the seat and not

floating or moving

- Free rev the engine and back off quickly, the engine should return to normal idle speed – if the engine drops below idle or stalls

increase the spring tension by half a turn

- Repeat this process until the engine free revs and returns to normal idle speed

- Test drive the car and ensure that when decelerating or changing gears that the engine does not backfire or stall. If backfiring or

stalling is noticed then check all connections made during the installation, otherwise increase the spring tension

TROUBLE SHOOTING

The following points should be checked if you find that your engine is dipping below normal idle, stalling or if the BOV is functioning

poorly. Please note, the following checks will cure 99% of problems experienced with a BOV.

- Check the vacuum hose for splits, cracks, loose connection, kinking or any obstruction – old or fatigued hose may collapse

under vacuum causing an obstruction.

- With the engine running remove the vacuum / boost hose from the nipple in the cap of the BOV, there should a loud hissing

sound. The engine should idle poorly, double check by covering the end of the hose with your finger – otherwise the hose is

blocked.

- Check to see if the BOV is blocked or contaminated with dirt or debris.

- Ensure that the vacuum / boost source is not shared and that the vacuum source is directly from the inlet manifold.

- Check the seal between the intercooler flange and the BOV. Make sure the supplied gasket is installed and the BOV Flange

is secured on the intercooler flange with the two factory bolts.

- Ensure the spring clamps are secured on silicon hoses and fittings.

1 2 3 4

Pas de commentaire

Turbosmart BLOW OFF & BYPASS VALVE KITS - Dual Port for: Manuel d'utilisateur Page 3