Turbosmart BLOW OFF VALVES - Race Port – Universal – New for Manuel d'utilisateur télécharger pdf

------------------------------------------------------------------------------------------------------------------------

IMPORTANT NOTES ON YOUR RACE PORT

 Use only silicone hose that is the correct size and pressure/vacuum rating for your application when fitting your Race Port

 Ensure that all plumbing is secured with suitable clamps or the correct fittings are used

 Your Race Port should be mounted at least 100mm from any high heat source or adequately shielded

 Check the vacuum level produced by your engine to ensure the right spring is installed in your Race Port for maximum response

RECOMMENDATIONS

 Turbosmart recommends that your Race Port is fitted and adjusted by an appropriately qualified technician

------------------------------------------------------------------------------------------------------------------------

HOW TO INSTALL YOUR RACE PORT

 Allow the engine to cool down before installing your Race Port

 Identify a suitable location along the intercooler/intake piping for the Race Port – this will need to be between the outlet of the turbo

and the throttle body ideally between the throttle body and the intercooler

 Remove the Race port from the weld on adapter by removing the V-Band clamp. The V-band clamp is removed by opening the

screw until it has reached the end stop, then pushing the head of the screw in a “syringe” like motion and lifting the Race Port off

the weld flange.

Step 1: Step 2: Step 3:

 Weld the adapter onto the intake pipe in your ideal position, then allow the adapter to cool down

 Put the V-Band clamp over the adapter before re-installing the O-Ring seal and the Race Port

 Open the V-Band clamp and place in position. Tighten the V-Band clamp screw until it is finger tight then turn an additional 2.5

turns or 4 Nm (3 ft/lbs) with an allen key. Be sure not to over tighten the screw as this will cause damage to the V-Band clamp

 Install the provided vacuum nipple into one of the ports in the top cap and install the blanking plug into the other.

 Identify a standalone vacuum / pressure source from a port after the throttle body and connect with correctly sized hose to the

vacuum/boost port nipple on the cap of the Race Port. Ensure this line is as short as possible

 Secure all silicone hose ends with correct clamps

 Start the engine and check for air leaks in the system

RACE PORT DIAGRAM

Product Name:

RACE PORT

Product Description: Blow off valve

Product Number: TS-0204-11XX

Bolt head

Squeeze

Lift off

Pull down

1 2 3

Happy motoring! 3

Résumé du contenu

Page 1

1 ------------------------------------------------------------------------------------------------------------------------ IMPORTANT NOTES ON YOUR R

Page 2

2 ACCESSORIES AND SPARE PARTS TS-0204-2001 BOV Race Port S/S Weld flange TS-0505-2007 1/16th NPT Male – 1/8 NPT Female fittings TS-0204-2104 BO

Page 3 - Happy motoring!

3 DO NOT USE ANY TURBOSMART PRODUCT UNTIL YOU HAVE CAREFULLY READ AND UNDERSTOOD THE FOLLOWING AGREEMENT. Please call if you have any question

Commentaires sur ces manuels

Pas de commentaire

Turbosmart BLOW OFF VALVES - Race Port – Universal – New for Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Turbosmart BLOW OFF VALVES - Race Port – Universal – New for . Turbosmart BLOW OFF VALVES - Race Port – Universal – New for 2011 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Turbosmart BLOW OFF VALVES - Race Port – Universal – New for