Turbosmart BLOW OFF & BYPASS VALVE KITS - Supersonic for: Manuel d'utilisateur Page 1

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Turbosmart BLOW OFF & BYPASS VALVE KITS - Supersonic for:. Turbosmart BLOW OFF & BYPASS VALVE KITS - Supersonic for: Subaru WRX (01-07), STi (01-08), Forester XT (06) User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 3
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
1
------------------------------------------------------------------------------------------------------------------------
IMPORTANT NOTES:
Please thoroughly read and understand these instructions before commencing this installation.
The thread on the cap for the vacuum source is AN#3. The standard swivel nipple can be changed to a AN#3 fitting if desired.
RECOMMENDATIONS
Turbosmart recommends that your Blow off valve (BOV) is fitted and adjusted by an appropriately qualified technician
Turbosmart recommends that a boost gauge be permanently fitted to the vehicle
------------------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR BOV
Please check that the following items have been provided in your WRX STI 08 Supersonic kit.
Quantity
Description
Use
1
WRX STI 08 Supersonic BOV
Model Specific blow off valve
1
34mm Blanking plug
To blank off standard plumb back hose
1
½” straight hose joiner
Re-route breather hose
1
½” rubber hose
Breather hose
1
½ ” tee piece joiner
Re-route breather hose
1
6mm Hose clamp
To secure vacuum hose onto vacuum nipple
1
Gasket
To seal the BOV to the intercooler pipe
1. Remove the standard BOV from the intercooler by removing the two bolts. Disconnect the vacuum line to the top of the standard
BOV.
2. Using pliers, carefully clamp onto the spring clamp on the plumb back hose and pull the BOV off the hose. Then carefully remove
the clamp completely.
Product Name: WRX Supersonic
Product Description: Fits WRX 01 – 07, WRX STI
01 08, Forester XT 06’
Product Number: TS-0205-1315, TS-0205-1216
Vue de la page 0
1 2 3

Résumé du contenu

Page 1 - HOW TO INSTALL YOUR BOV

1 ------------------------------------------------------------------------------------------------------------------------ IMPORTANT NOTES: • Pleas

Page 2

2 3. Fit the supplied 34mm blanking plug to the plumb back hose 4. Remove the standard hose breather 5. U

Page 3

3 IMPORTANT NOTES ON SETTING THE SPRING TENSION - Adjustment to the BOV is made by rotating the cap. To increase spring tension rotate in the d

Commentaires sur ces manuels

Pas de commentaire