Turbosmart BLOW OFF & BYPASS VALVE KITS - Supersonic for: Manuel d'utilisateur télécharger pdf (Page 2)

3. Fit the supplied 34mm blanking plug to the plumb back hose

4. Remove the standard hose breather

5. Using the provided ½” tee piece, connect the standard oil breather lines on the left hand side of the intercooler in the orientation

shown in the picture below and run the provided ½” hose under the intercooler to the oil breather line on the other side of the

intercooler, using the provided ½” straight joiner to join the rubber hose to the existing breather line on the right hand side.

6. Install the WRX Supersonic BOV to the intercooler using the standard screws. Re-fit the Vacuum hose, then start up the car and

check for leaks.

½” Tee piece

½” rubber hose

1 2 3

Pas de commentaire

Turbosmart BLOW OFF & BYPASS VALVE KITS - Supersonic for: Manuel d'utilisateur Page 2