Turbosmart BOOST CONTROLLERS – ELECTRONIC - e-Boost2 (2005-cu Manuel d'utilisateur télécharger pdf (Page 4)

www.TURBOSMARTONLINE.com

 The E-Boost 2 requires a vacuum/pressure signal from the intake manifold to function. A combination of poly tube and silicone

hose is used to connect the E-boost 2 to a adequate vacuum/pressure signal. Route the poly tube from the E-boost 2 head unit

through the fire wall approximately 100mm (4”) only as the poly tube is not rated to the high temperatures of the engine bay.

 Use the connecting barb to join the poly tube to the 3mm ID silicon hose at the firewall/bulkhead. Ensure the poly tube is pressed

all the way onto the connecting barb

 Route the silicon hose through the engine bay and connect it to a pressure/vacuum signal from the inlet manifold. Use the supplied

tee piece if necessary.

 Secure all connections with the supplied hose clamps

e-Boost 2

Silicone Hose

Joining nipple

Poly tube

Firewall

1 2 3 4 5 6 7 8 9 ... 37 38

Pas de commentaire

Turbosmart BOOST CONTROLLERS – ELECTRONIC - e-Boost2 (2005-cu Manuel d'utilisateur Page 4